Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
cp:start [2018/05/28 22:29]
127.0.0.1 external edit
cp:start [2020/06/25 18:03] (current)
Alan Shea intelicompact replaced by InteliGen 200
Line 2: Line 2:
 {{ :​cp:​c61-genset-control-tower-3p.jpg?​401|}} {{ :​cp:​c61-genset-control-tower-3p.jpg?​401|}}
  
-The unified control system uses ComAp [[http://​comap.cz/​products/​detail/​intelicompact-nt-mint/​|InteliCompact]] series generator controllers. These controllers allow full control of all generator functions in a non-proprietary architecture. The system can control basic gensets (all sensors etc direct wired) or communicate with many computer controlled gensets directly through a CAN network. (Note: Some gensets with built in proprietary controls will not interface with the ComAp products--contact [[http://​www.comapllc.com|ComAp]] for specific information).+The unified control system uses ComAp [[http://​comap.cz/​products/​detail/​intelicompact-nt-mint/​|InteliCompact]] series generator controllers. ​[**//​Replaced with [[https://​www.comap-control.com/​products/​gen-set-paralleling-controllers/​inteligen/​inteligen-200 |InteliGen 200]] Controller//​**] ​These controllers allow full control of all generator functions in a non-proprietary architecture. The system can control basic gensets (all sensors etc direct wired) or communicate with many computer controlled gensets directly through a CAN network. (Note: Some gensets with built in proprietary controls will not interface with the ComAp products--contact [[http://​www.comapllc.com|ComAp]] for specific information).
  
-The system also uses a [[http://​comap.cz/​products/​detail/​mainscompact-nt/​|MainsCompact]] to interface with local utility or an auxiliary power source -- for instance, a portable generator used for extremely low usage times. ​+The system also uses a [[http://​comap.cz/​products/​detail/​mainscompact-nt/​|MainsCompact]] to interface with local utility or an auxiliary power source -- for instance, a portable generator used for extremely low usage times. ​[**//​Replaced with [[https://​www.comap-control.com/​products/​switchgear-controllers/​mains-controllers/​intelimains-210 |InteliMains 210]]//**]
  
 The system is capable of running any one source, or all sources paralleled together at once. It can start, run, and stop generators from a remote location (such as a surgery building or operating room), or automatically as the load fluctuates. It also will monitor fuel levels and alarms and provide audible and visual warning of needed service. ​ The system is capable of running any one source, or all sources paralleled together at once. It can start, run, and stop generators from a remote location (such as a surgery building or operating room), or automatically as the load fluctuates. It also will monitor fuel levels and alarms and provide audible and visual warning of needed service. ​
cp/start.txt · Last modified: 2020/06/25 18:03 by Alan Shea
 
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
Recent changes RSS feed Donate Powered by PHP Driven by DokuWiki